Sears 72671 - Manual (Page 42)

Installation Instructions
(continued)
31 I Ci ж
Installing the Anti-Tip Device
WARNING:
• Range must be secured with an approved Anti­
Tip device.
• Unless properly installed, the range could be
tipped by you or a chUd standing, sitting or
leaning on an open door.
• After installing the Anti-Tip device, verify that it
is in place by carefiilly attempting to tilt the range
forward.
• This range has been designed to meet all
recognized industry tip standards for all normal
conditions.
• Tbe use of this device does not preclude tipping
of the range when not properly installed.
• If the Anti-Tip device supplied with the range
does not fit this application, use the universal
Anti-Tip device WB02X7909.
1. Mark the wall where the RIGHT EDGE of the
nmge is to be located. Be sure to allow for the
countertop overhang if you intend to install the
range next to cabinets.
2. Locale the outside edge of the device ZY/' (5 4 cm)
toward the center of the range from the marked
edge of the range.
3* Using the device as a template, mark the position of
the hole for the screw.
4» For wood construction, drill a pilot hole at an angle
of 20 depees from the horizontal. A nail or awl may
be used if a drill is not available.
Mount the Anti-Tip device with the screw provided.
For cement or concrete construction, you will need a
1/4" X VA" kg bolt and a 1/2" O.D* sleeve anchor,
which are not provided. Drill the recommended size
hole for the hardware.
Install the sleeve anchor into the drilled hole and then
install the lag bolt through the device. The bolts must be
properly t ightened as recommended for the hardware.
5. Slide the range against the wall, and check for
proper installation by grasping the front edges of the
rear surface unit openings and caiefuiiy attempting
to tilt the range forward.
WHEN AEL HOOKUPS ARE COMPLETED:
MAKE SURE ALL OF IHE CONTROLS ARE
LEFT IN THE OFF POSITION.
MAKE SURE THE FLOW OF COMBUSTION
AND VENTILAnON AIR TO THE RANGE IS
UNOBSTRUCTED.
Converting to LP gas
(or converting back to natural gas from LP)
This range leaves the factory set for use with natural
gas. If you want to convert to LP gas, the conversion
must be performed by a qualified LP gas installer.
The conversion instructions, sticker and LP orifices
can be found attached to the range next to the pressure
regulator.
There is a second set of instructions included in the
envelope containing the product wiring diagrams on
the back of the range. Keep these instructions and the
orifices in case you want to convert back to natural gas.
42