Installing head into cabinet, Attaching motor to machine, Attaching motor to – SINGER W7317 User Manual
Page 5: Machine
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1. INSTALLING HEAD INTO CABINET
1) Loosen the two hinge screws under the holes in the rear edge
of the machine bed ¡Fig. 11.
2! Raise hinge-pins in the cabinet cut-out, slip machine head on
the pins, and tighten hinge screws securely.
2. ATTACHING MOTOR TO MACHINE
Fig. 2
Then tighten the motor bracket tastening-screw tightly. NEVER OIL THE MOTOR.
— 4 —
1) Place the motor bracket over the tongue of the arm under
the balance wheel, the screw hole in the center of the
tongue can be seen through the slot of the motor bracket
IFig. 2).
2! Then insert the screw and after shifting the motor upward
as far as it will go, tighten the screw.
3)
Slip the motor belt into the groove of the balance wheel,
and then slip the belt into the groove of the motor pulley.
4)
Adjust the belt tension by loosing the motor bracket fas
tening-screw
and
let
the
motor
drop
downward
until
the
correct belt tension has been reached.