Setting up the machine – SINGER 10UJ13 User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SETTING UP THE MACHINE
It is important that this sewing machine be set up
in the correct manner before use,
1-1 Correct installation of the motor
• Loosen the two belt cover screws and detach
the belt cover.
• The bracket set screw {Figure 2), bracket set
washer (Figure 2) and the belt are packed in
this set and attached to the machine body
by fastening the set screw while setting the
belt as shown in Figure 3.
Belt tension is considered adequate, if it
bends slightly when pressed by finger as
shown in Figure 4, When the belt tension is
not adequate, further adjust the tension by
moving the belt tension adjusting nut
(Figure 4) to the right or left.
• Replace the belt cover.