Four-step buttonholes (cont’d.) – SINGER 484.1244180 (Sold at Sears) User Manual
Page 27
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Four-Step Buttonholes (Cont’d.)
****"* *""*"**^**™***""^ Step C: Front Bartack
* Raise needle out of fabric.
* Tlirn stitch-length dial to “C”.
* Sew four stitches ending at point (1).
n
U y
A
B C
0
B
C
D
Step D: Left Side Stitching
^
Raise needle out of fabric.
* Turn stitch-length dial to “D”.
* Sew side stitching until it meets rear bartack
at (2). The buttonhole is now complete.
Changing Stitch Density
To obtain similar stitch density on both sides of
the buttonhole, the stitch balance control locat
ed in the center of the stitch length dial can be
used as follows:
With balance control centered, make a test
buttonhole.
* If stitches on right side are too far apart,
turn control towards the right (clockwise) with
fingertip to increase density.
^ If stitches on left side are too far apart,
turn control towards the left (counterclockwise)
with fingertip to increase density.
25