Removing bobbin case, Replacing bobbin case, Threading the bobbin case – SINGER 484.1244180 (Sold at Sears) User Manual
Page 32
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Removing Bobbin Case
^
Remove needle and needle plate.
^
Open slide plate and lift out bobbin.
^
Using small screwdriver, turn bobbin case
retainer (1) in direction of arrow (2) as far as it
will go.
^
Lift out bobbin case (3).
Using soft brush, brush lint from case and other
mechanical parts in the bobbin area.
Replacing Bobbin Case
^
Insert case with a back and forth motion
so front of case lies under position plate (4).
^
With small screwdriver, turn bobbin case
retainer in direction of arrow (5) to lock case
in place.
^
Reinsert needle, needle plate, and bobbin and
close slide plate.
Should slide plate become detached, replace as
follows:
^
Place slide plate in slide way with the front
edge close to, but not covering, the retaining
spring (6).
^
With a screwdriver, lift each end of spring
into the side grooves on the underside of the
plate.
^
Draw plate gently towards you to engage
spring. Then, close plate.
30