Operating tips, Ltan the lint flltlr, Load m dryer properly – Maytag INTELLIDRY MD-15 User Manual
Page 5: Neck the moisture monitor, Add a fabric softener sheet (ie desired)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
(LtAN THE LINT flLTLR
• After each load.
• To shorten drying time.
• To operate more efficiently.
Do not operate the dryer
without the lint filter in place.
LOAD m DRYER PROPERLY
By placing only one wash load in the
dryer at a time.
Avoid very small loads or mixing
heavyweight and lightweight clothes.
When only one or two articles need
drying, add a few similar items to
improve tumbling and drying efficiency.
When drying large, bulky items such
as a blanket or comforter, it may be
necessary to reposition the load during
the cycle to ensure even drying.
(NECK THE MOISTURE
Indicator lights in the moisture monitor will
display when an IntelliDry cycle is in oper
ation. The top light will blink on and off. As
loads dry, there will be longer pauses
between each blink. No lights will display
during Time Dry or Air Fluff.
The bottom light in the monitor will remain
on until the cool down portion of the cycle
starts. During cool down the dryer contin
ues to tumble the load in unheated air to
help minimize wrinkling.
NOTE: The top monitor light
may not blink when small loads
of heavy, bulky items are dried,
such as rugs or sweaters.
ADD A FABRIC SOFTENER
SHEET (IE DESIRED)
• After loading the dryer.
• To control static cling.
Before the load becomes warm.
This helps prevent greasy-looking
And remove any used softener
sheets from the dryer to prevent
greasy-looking softener stains.