Directions for using the attachments – SINGER W12 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
I'M
DIRECTIONS FOR USING THE ATTACHMENTS
Hemming
Eaise the take-up to its highest point, remove the presser-
foot and in its place attach the hemmer. Trim the edge of cloth
on a curve and insert in hemmer far enough to permit the needle
to enter the cloth at its extreme edge (See Fig. 2 above), then
proceed to sew, keeping the edge turned as it feeds through.
Felling
The hemmer is also the feller. Sew together two pieces of
cloth with the under edge projecting between % and inch
beyond the upper edge y then trim the edges if necessary and
open the work flat wrong side up, and fold the wider edge,
toward the left, over the narrow edge, and then pass the folded
edge into the feller the same as in ordinary hemming.
Illustration above represents an operator in the act of com
pleting a fell.
I
m
iii
iH
iS
: H