SINGER W219R - Manual (Page 10)

14
SAMPLES OF CREATIVE EMBROIDERY
"A" Sew a few stitches at 5 width then turn knob back to O for a short period. Count if
necessary, to establish a rhythm. (A, Fig. 20) '
' '''' 2 and number 0
"C" Gradually move the zigzag width control from 0 to 5 and instantly return to O Then
repeat likewise. (C, Fig. 20). 'u lo u. men,
Set zigzag width at 5,^ch length at 2. Sew a few zigzag stitches. Turn the drop feed
no ( ig. 5 ) t o " position for 3 or 4 stitches then normal position again By
ojraung the drop feed knob rhythmically it is not necessary to count stitches. (D
Set drop feed knob at " 222£ ..
width control at the number 5 position. Take 3 or 4
stitches, leave needle in fabric and pivot fabricon
needle to make next daisy petal. Continue until
flower design is completed. Lock threads by setting
stitch width at O and sewing 3 or 4 stitches in center
of design. (E, Fig. 20).
"D’
”E’
D WWWrtWA\VVWirW#AWWAWi'A1
'"1'^
Fig. 20
15
CREATIVE EMBROIDERY
Be sure zigzag presser foot and zigzag needle plate are in place.
1. Set pattern selector (C, Fig. 17) at "1 ” position.
2. With the zigzag width control {D, Fig. 17) set at the Number 5 and stitch length control
{A, Fig. 17) as near O as possible without stopping the feeding action, a sating stitch is
produced (Fig. 19).
4. With the machine set for a short stitch length, different designs can be made by turning the
zigzag width control back and forth between 0 and 5 or any other combinatio"s of widths.
Try setting the zigzag width control (D, Fig. 17) at the first line and the various other lines.
Set a rhythm for yourself and then proceed. After a while you will become quite skillful,
varying your designs by the speed of the machine, stitch length and manipulation of tiie
zigzag width control.
Fog. t9