SINGER W219R - Manual (Page 5)

WINDING THE BOBBIN
Fig. 3
Disengage the hand wheel (I, Fig 4| from the cin^hi i. ■
Fig. 4) toward you or counter clockwise PlTc a It ^7
Icad thread through the arm thread guide (3 Fig Ttl 7 f T
bobbin edge and place bobbin on spindle of bobbin winder nuing‘'tr''t I
over small pin on spindle. Push bobbin (5 Flo ai i ,i u '“'"8‘^e notch on bobbin
!U„
,l™„. ' ' -"I ll»“ «.'•« .»J looKi, ,h.n
UPPEFi THREADING
4.
Turn the hand wheel toward you to raise the take,
up lever to its highest position.
Place a spool of thread on the spool pin
t.",
S” “¿ft""" «'’™
Draw the thread up through the check spring (0
Fig 6^ ^ (E,’
Then up through the eye of the take-up lever (F
h»g-6) from right to left.
' '
Lead thread down, through the thread guide (G, F
ig. 6) then through the needle bar guide (I, Fig 6)’
Thread needle from front to back, drawing it
through about 3 or 4 inches. Hold the end of
he upper thread Ic-sely and turn the hand wheel
toward you until the needle goes all the way down
and comes back up. Aloop (Fig. 7) will be formed
over №e upper thread which then can be pulled out
traight. Place both thread ends under the pressed
foot and draw toward the back of the machine
leaving both threads three or four inches long.
F B A
Fig. 6 F«g. 7