Maytag AGS1740BDQ - Manual (Page 8)

j J Maintenance
Owen Door Leweling Legs
A
CAUTION
Do not piace excessive vveight on or stand on an open
oven door. This could cause the range to tip over, break ttie
door, or injure the user.
Important: The oven door on a new range may feel “spongy”
when it is closed. This is normal and will decrease with use.
Oven Window
To protect the oven door window:
1. Do not use abrasive cleaning agents such as steel wool
scouring pads or powdered cleansers as they may scratch
the glass.
2. Do not hit the glass with pots, pans, furniture, toys, or other
objects.
3. Do not close the oven door until the oven racks are in
place.
Scratching, hitting, jarring or stressing the glass may weaken
its structure causing an increased risk of breakage at a later
date.
Storage Drawer
A
CAUTION
Do not store plastic, paper products, food or flammable
materials in this drawer. The drawer may become too warm
for these items when the oven is in use.
The storage drawer can be removed to allow you to clean
under the range.
To remove:
1. Empty drawer and pull out to the first stop position.
2. Lift up the front of the drawer.
3. Pull out to the second stop position.
4. Grasp sides and lift drawer up and out.
To replace:
1. Fit the ends of the drawer glides into the rails in the range.
2. Lift up the front of the drawer and gently push in to the first
stop position.
3. Lift drawer up again and push until drawer is closed.
A
CAUTION
Be sure the anti-tip bracket secures one of the
rear leveling legs to tlie floor. This bracket
prevents the range from accidentaily tipping.
m*
Be sure the range should be leveled when
installed. If the range is not level, turn the
leveling legs, located at each corner of . , '
..
the range, until range is level. |
anti tip
éaf BRACKET
LEVELING LEO
Oven Light
A
CAUTION
Disconnect power to range before replacing light bulb.
Allow oven to cool before replacing light bulb.
and bulb are cool before touching. * Make sure biilb cover
To replace oven light bulb:
1. When oven is cool, hold bulb
cover in place, then slidewire
retainer off cover.
Important:
Bulb cover will fall if not held
in place while removing wire
retainer.
2. Remove bulb cover and light bulb.
3. Replace with a 40-watt appliance bulb.
4. Replace bulb cover and secure with wire retainer.
5. Reconnect power to range. Reset clock.
Convenience Outlet
(Canadian models only}
The convenience outlet is located on the
lower left side of the backguard. Be sure
appliance cords do not rest on or near
the surface element. If the surface
element is turned on, the cord and
outlet will be damaged.
The convenience outlet circuit breaker
may trip if the small appliance plugged
into it exceeds 10 amps. To reset the circuit breaker, press the
switch located on the lower edge of the backguard.
CIRCUIT BREAKER