SINGER 14U22 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Correct sewing cannot be obtained when machine is threaded incorrectly.
Threading is diagrammed on the inner side of the looper cover and identified with colors on the various
thread guides.
(1) Open looper cover. Thread the right looper in the order 0 to (§) as indicated in the figure below,
(threading points marked in orange)
• How to thread your machine correctly
Wind thread around thread
guide when threading (2) as
shown in figure below.
While holding thread with finger, pass it
between the tension discs and pull thread
down to make certain it is properly located
in between the tension discs.
• Use tweezer provided in the accessory set when
threading looper thread hole (8) .
• Draw about 5cm (2 inches) of thread from the
looper thread hole.