Changing needle – SINGER W1210 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
Changing Needle
Set needle in the highest
position by turning handwheel
towards you.
Loosen needle clamp screw and
take out needle.
With flat face away from you,
insert a new needle into groove
of needle bar.
Push needle until it reaches
stopper (a) and tighten needle
clamp screw firmly.
Always use a straight needle with
a sharp point.
Using defective or worn needles
not only causes stitch skipping,
breakage of needles or snapping
of thread; it also can damage
hook and needle plate.
Proper needle
straight shaft
sharp point
Advertising