Threading the bobbin case – SINGER 4314 User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
THREADING THE BOBBIN CASE
1.
Hold
bobbin
so
that
thread
unwinds
in
the
direction
shown,
and
put
bobbin
into
bobbin
case.
2. Pull thread into notch A, draw it back under
the tension spring and back into slot B.
3.
Draw
approximately
10
cm
(4
inches)
of
thread across the bobbin.
4.
Close slide plate allowing thread to enter slot
between the needle plate and slide plate.
12
Advertising