SINGER 4314 - Manual (Page 36)

buttons
• Pattern Group Selector; 1
U I J
• Needle Position:
• Stitch Width: To suit button
• Stitch Length: 0
• Snap-in Feed Cover
• General Purpose Foot
——
xaa
AA/\/\
0 1 2__ 3__ i.
0 1 2 3 4
EX
ATTACHING A BUTTON
Flat buttons can be sewn on by nnachine using
the zig-zag stitch.
• Attach snap-in feed cover to general pur­
pose needle plate.
1. Set stitch width selector at 0.
• Set needle position at leftL..
• Place button positioned on fabric under
foot and lower needle into centre of left
hole.
• Lower presser foot.
• Turn hand wheel toward you until the ne­
edle rises out of button hole and is just
above the presser foot.
2. Set stitch width selector to a medium width
zig-zag setting.
• Continue turning hand wheel until the
needle is above right hole, adjust stitch
width, as necessary, until neecfle enters
the centre of the right hole.
• Take six or more zig-zag stitches and
finish with the needle on the left.
3. Move stitch width selector to
o
and take a
few stitches to fasten threads.
• Pull thread ends through to back of gar­
ment knot close to fabric and snip off
loose ends of thread.
34