Caring for your machine, Replacement of moving cutter, Changing light bulb – SINGER WSL216 User Manual

Page 17: Cleaning and oiling

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

4. CARING FOR YOUR MACHINE

REPLACEMENT OF MOVING CUTTER

Should it become necessary to replace
moving cutter, due to it becoming blunt,
apply the following procedure. A spare cutter
will be found in your accessories.

NOTE: You should not need to replace fixed

cutter, which is made of a special

hard alloy material.

FIRST REMOVE THE POWER PLUG FROM
THF SUPPLY^SOCKET^OUTLET.

Open side cover. Loosen set screw for

protection cover with screwdriver in the

accessories. Loosen release lever with

spanner in the accessories, and take out
protection cover.

While keeping set screw of moving cutter

from rotating with screwdriver, loosen

nut on the other side with spanner, and
take out moving cutter.

Set the replacement cutter in positon,

and secure it with screw and nut.

Assemble protection cover in the reverse
way as described in step 1 above.

Side cover

Release lever

Light cover

CHANGING LIGHT BULB

The sewing light is located under the

machine arm, as shown, and illuminates the
sewing area only.

DISCONNECT

MACHINE

FROM

THE

POWER SUPPLY BY REMOVING PLUG

FROM SOCKET-OUTLET.

DO NOT REPLACE BULB OF MORE THAN

15 WATTS MAX.

To change bulb, pull down light cover,

remove old bulb by unscrewing. Replace

with new bulb.

CLEANING AND OILING

To keep you machine running smoothly, it is

necessary to keep it clean and lubricated at

ail times.

FIRST

DISCONNECT

MACHINE

FROM

POWER SUPPLY BY REMOVING PLUG

FROM SOCKET-OUTLET.

1. Open both front and side covers. Using

the brush provided, remove dust and lint
that have accumulated around the whole

exposed area.

2. Lay the machine on its back and take off

the lint tray by removing the single
securing screw.

Using the brush provided, remove any
dust and lint that may have accumulated

in the tray and bottom of the machine.

Replace the tray and secure by re-tighten-
ing the screw.

3.

Apply a few drops of oil to the points

indicated by arrows.

ALWAYS

USE

A

GOOD

QUALITY

SEWING MACHINE OIL.

4. Wipe off any stains with a soft cloth.

30

Advertising