Adjusting and changing “v” belt – SINGER W311 User Manual
Page 29
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
28
ADJUSTING AND CHANGING “V” BELT
Fig. 58
Fig. 59
Following are the instructions for adjusting and changing the “V” belt;
(1) Remove three screws holding rear cover (Fig. 58) by tipping it out
pivoting around the hand wheel away from the front of the machine.
(2) To adjust “V” belt, loosen screws (A, Fig.
59
) and move bracket B
down to tighten.
(3) To remove “V” belt:
at the bottom and
up to loosen belt and
(A)
(B)
(C)
(D)
(E)
(F)
Remove top cover.
I con
(C'
Fin
Loosen screws “
a
” (Fig. 59) and move bracket B” to its highest position.
Slip belt off motor pulley and then over hand wheel.
Replace “V” belt by slipping it over hand wheel and then over motor pulley.
Adjust as noted under No. 2.