Placing bobbin case in shuttle – SINGER W311 User Manual

Page 8

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

* V •

•* f » ■

SLOT

/-■ t- Y

1 - ''

. ‘ \

»■

I \

\

/

■"X

Í

L ] V

TENSION SPRING

Fig. 8

N

Fig. 9

Fig. 10

PLACING BOBBIN CASE IN SHUTTLE

Raise needle bar to highest position, and slide cover plate

to the left. (See 17, Fig. l) Hold the bobbin case latch, (D,

Fig. 11) between the thumb and forefinger of the left hand,
with at least three inches of thread running from the top of

the bobbin case to the right. Insert and center the bobbin
case on the stud of the shuttle body, (C). Be sure the
bobbin case finger, (E), is opposite the shuttle race notch (A).
Press the bobbin case (B) info the Shuttle as far as possible
until latch catches on the center post of the shuttle. THEN

release the bobbin case latch, (D). Press bobbin case again

after latch has been released to make sure the bobbin case

is locked securely in place. Close the cover plate.

Advertising