Threading chart – SINGER WREX 101 User Manual
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Use any type thread which is suitable for the fabric being
’ sewn. This includes mercerized, 00, silk and synthetic
The thread is passed through rear thread guide A, then slides
between two tension discs, B under pin C, through front
thread guide D , . . then down through needle clamp guide
hole E . . . and entering from the underside of needle hole F.
Leave thread about 2 to 3 inches past needle hole.
I To thread needle at point F
Swing work plate out of way
Depress cylinder out of way
with knee lifter (R-152)
Hold thread between index
finger and thumb
End of thread must be stub
not feather edge.