Preparing to sew, Starting to sew – SINGER W1066 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
8. PREPARING TO SEW
1. Hold the end of the upper-thread with the left hand, leaving it
slack from the hand to the needle.
2. Turn the balance wheel towards you to raise the needle bar to its
highest position.
3. Pull the thread you are holding, and the lower thread will be brought
up with it through the hole in the needle plate, as shown (Fig. 10)
4. Place both ends of the upper and lower thread under and to the back
of the presser foot (Fig, 11).
'
9. STARTING TO SEW
1. Place the fabric to be sewn beneath the presser foot.
2. Lower the presser foot by lowering the presser bar lifter.
3. Start sewing by slowly turning the balance wheel towards you while
gradually working the foot control.
ALWAYS TURN BALANCE WHEEL TOWARDS YOU!