Embroidery and monogramming, Darning – SINGER W1066 User Manual
Page 23
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
24. EMBROIDERY AND MONOGRAMMING
It is quite easy to follow a design or to work free-hand when Embroidering
or Monogramming (see Fig.
35
). Remove the Presser Foot completely
and turn the Drop-Feed Control to the LEFT to 'DOWN' so that the
Feed-Teeth are fully lowered (see Page 101.
Stretch fabric tightly in an Embroidery hoop and place under the Needle.
Set the Stitch width to the size you prefer or, set at '0' and create your
own widths by movenrtent of the Hoop to suit your pattern. Operate the
Machine rather fast whilst moving the Hoop with both hands. Work care
fully and be sure to keep fingers out of the path of the Needle.
25. DARNING
Remove Presser Foot and lower Drop Feed as for Embroidery above.
Prepare fabric to be mended as above and place under foot. Using a fine
thread and thick Needle, stitch once around hole to incorporate all the
frayed ends.
Next cover hole with vertical lines of Stitching as close together as possible,
covering hole (Fig. 36). Then repeat the operation from side to side until
the hole has again been covered. Once the Machine is in motion, the cloth
must not stand still.
ALWAYS REMEMBER TO RETURN FEED TEETH TO 'UP' POSITION BEFORE RESUMING NORMAL SEtf
- 2 1 -