Cording, Zipper sewing – SINGER W1066 User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Release the- thumb screw on rear side of foot. Lower needle into the
side notch of the foot and-check position of the foot to avoide needle
strike the foot. Fasten thumb screw to the-lock make sure that the foot
into position.
Fold edge of the material-by and place zipper under the folded portion
of the material where you wish to attach the zipper
Stretch close to the edge of the zipper foot along zipper teeth.
To sew on the opposite side of the zipper, loosen thumb screw and slide
the foot over and sew the same way.
20. ZIPPER SEWING
21. CORDING
Using the Zipper Foot as above, fold a bias strip over a length of cord
(Fig. 32). and adjust the position of the Foot as above so that the Needle
will sew close to the corded fabric. You can then use the finished 'welting'
to sew between plies of material to produce a 'piping' effect on the edge
of your work.
1 9 -