Installing the customer assistance label, Installing the power cord – Xerox 7024 User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INSTAUATiON
Installing the customer assistance label
1
.
2.
Record the serial number on the customer assistance label
and in the User Handbook, Section 8, Requesting assistance.
The serial numt>er is located under the printer cover to the
left of the imaging cartridge.
Record the customer support center telephone number on
the customer assistance label. The number is in the User
Handbook, Section 8, Requesting assistance.
Remove the cover backing from the customer assistance label
and place the label on the right rear corner of the terminal.
Installing the power cord
1. Make sure the power switch at the right side of the terminal
is off.
2. Plug one end of the power cord into the connector at the
rear of the term i nal.
3. Plug the other end of the power cord into the wall outlet.
4. Turn the power switch on.
Note: Do not install the terminal on the same electrical circuit
as an air conditioner, copier machine or other high consumption
electrical appliance. These appliances can cause electrical "draw
downs” when they operate-temporarily reducing the power
available for other equipment on the circuit-and could damage
your terminal.
xviii
TELECOPIER 7024 USER HANDBOOK