Xerox 7024 - Manual (Page 140)

PROBLEM SOLVING
Error Messages Table
ERROR MESSAGES SOLUTION
SET DOCUMENT AGAIN The document is not set in the ADF correctly. Insert the
document in the document feeder again.
RELOAD ORIGINALS Transmission was attempted without inserting a document.
Insert document and try again.
POLLING IN USE Only one polling document can be set up. Try again after the
polling operation has been completed.
ADD PAPER TO TRAY Replace recording paper.
CLEAR PAPER JAM Recording paper will not feed correctly. Reset recording paper.
PLEASE CLOSE COVERS
Press firmly on the left hand, printer and scanner covers to close
securely.
HANG UP TELEPHONE Return the telephone handset to its cradle. Press stop to cancel
alarm.
SCAN LAMP FAILURE The lamp is not sufficiently bright or is defective. Turn the
power off and back on or call for service.
NOT AVAILABLE
Copy is attempted with a delayed start job pending from the
ADF.
MEM FULL SEE MANUAL The memory capacity has been exceeded. Press Enter within one
minute to store the scanned originals. Otherwise, clear some of
the memory or transmit document from the document feeder.
CANNOT IMPLEMENT NOW All the delayed commands have been used. Press Stop to
discharge document or repeat the operation again after the
current operation is completed.
NOTHING STORED The one touch, speed dial or group number selected has not
been programmed in the telephone directory.
Try programming the number again.
MEMORY NOT AVAILABLE The internal memory in your unit was full before you began your
operation. Clear some of the memory by deleting a delayed
command or transmit from the document feeder.
NO PENDING JOBS A command is not programmed when printing or cancellation of
a delayed command is requested.
CANNOT TRANSMIT Transmission is attempted when a delayed start job from the
ADF is set up. Press Stop to discharge the document or repeat
the operation again after the current operation is completed.
PLEASE WAIT The machine is performing desired operation.
REPLACE IMAGING FILM Replace the imagi ng fi 1 m.
LOW PAPER-ADD PAPER The terminal is low on paper. Add paper.
CLOSE PAPER TRAY Close the paper tray and try the operation again.
8-2 TELECOPIER 7024 USER HANDBOOK