NordicTrack NEL07940 - Manual (Page 5)

2. Have another person hold the Upright (2) in the posi­
tion shown. Make sure that the Upright is turned as
shown in drawing 3 beiow, and that the Upper Wire
Harness (30) is on the right side of the indicated
metai plate.
Connect the Upper Wire Harness (30) to the Lower
Wire Harness (42). Carefuiiy putt the upper end of
the Upper Wire Harness to remove the stack from
the Wire Harnesses. Insert the Upright (2) into the
Frame (1). Be careful to avoid disconnecting or
pinching the Wire Harnesses. Attach the Upright with
two M10 X 108mm Button Screws (70), two M10 Split
Washers (73), and two 7.6mm Spacers (47). Make
sure that the curved sides of the Spacers are fac­
ing the Upright. Be careful to avoid damaging the
Wire Harnesses with the Button Screws. Do not
tighten the Button Screws yet.
3. Slide a Weld Spacer (28) onto the axle on the left side
of the Upright (2), with the open side of the Weld
Spacer facing the Upright. Apply a small amount of
grease to the axle.
Slide an Upper Body Arm (29) onto the axle on the left
side of the Upright (2). Using the included Push Nut
Tool (96), tap a Push Nut (31) onto the axle; make
sure that the Push Nut is turned as shown in the
inset drawing.
Attach the other Upper Body Arm (29) to the right
side of the Upright (2) in the same way.
4. Look inside one of the Handlebar Covers (26) and
locate the square tabs connecting the two halves.
Gently lift the tabs and disconnect the halves.
Hold the two halves of the Handlebar Cover (26)
around the tube on the left side of the Upright (2). Align
the halves and press them together until they lock.
Attach the other Handlebar Cover (26) to the right side
of the Upright (2) in the same way.