Ronco 6000 Series Standard Stainless Rotisserie Oven - Manual (Page 19)

19
Showtime ® Rotisserie
ACCESSORIES
19
Solid Flavor injector
(sold separately)
This expanding tip injector can be loaded with pieces of garlic or diced onions, herbs,
spices, diced peppers, fruit pieces or diced ham for flavoring. For pastries try inserting
chocolate chips, sprinkles, nuts and other seasonings.
1) Load the Expanding Tip with
garlic, fresh or dried herbs, nuts
or other solid food items.
2) Insert the filled Expanding Tip
inside the Locking Ring.
3) Place the Insert Rod inside
the injector Cylinder. Plunger
should be pulled back as far as
it can go. The Insert Rod is used
to push the spices through the
Expanding Tip.
4) Inject meat, poultry or pastry
with small pieces of solid food
then withdraw the whole
Injector. Pull the plunger back.
Repeat as necessary.
How to Load injector
To inject small
whole garlic cloves,
fresh herbs or
seasonings into
meat or poultry, you
must first insert the
filled Expanding Tip
as deep as it can
go into the food,
then depress the
plunger.
Depress plunger while tip is inserted
into the meat (or pastry). Withdraw the
injector then pull the plunger back,
reload the Expanding Tip and repeat
throughout the meat or poultry.
Difficulty in piercing through tough skin,
heavy fat or tough meat? Start a slit
(about 1 ½” deep) into the meat with
the point of a small knife.
CAUTION: FOR FOOD PREP ONLY.
KEEP AWAY FROM CHILDREN.
important Safeguards
While inserting this Solid Flavor Injector
into meat, poultry, or any other food,
be careful not to push Injector into your
hand. The Expanding Tip is sharp.
Wash Injector thoroughly with soap and
water after each use. Meat and poultry
residue is unhealthy and can cause the
expanding Tip to crack or break.
If the Injector seems too large for your
hand, fill the Expand-
ing Tip only ½ or ¾ full
(then the plunger is
less extended and will
fit smaller hands).
important: Please
don’t leave the Insert
Rod in the Expanding Tip. It can stretch.
After each use, pull plunger all the way
back and then retract the Insert Rod
from the Expanding Tip by tapping the
point down gently onto a smooth, hard
surface.
Plunger
Cylinder Insert Rod
Expanding Tip Locking Ring