Looping a sequence – Akai MPC 2000xl User Manual
Page 55
Page 44
Chapter 3: Recording Sequences
Looping a Sequence
During playback, the designated region of the sequence will be played back repeatedly until STOP
is pressed. During recording, after the set number of bars have been recorded the REC mode
automatically changes to the OVERDUB mode and the sequence will then play repeatedly until
STOP is pressed, allowing you to keep dubbing on top of the sequence (further recording is added
to the original, the original is not deleted).
.......................................................
..................................................................................................
Sq:
01-(Sequence01)
TrMUTE
SOLO
Tr +
Now:001.01.00
STEP
EDIT
Tr -
™:120.0(MAS)
Timing:1/16
Tsig: 4/ 4
Tsig: 4/ 4
Count:OFF
Loop:
OFF
Bars: 0
Bars: 0
Tr:01-Track-01
ON:YES
Pgm:OFF
S:MIDI :10A-Device10
S:MIDI :10A-Device10
Velo%:100
To set the loop ON or OFF, select the
Loop:
field with the CURSOR keys and rotate the DATA
wheel.
To set the range of the loop, press the OPEN WINDOW key.
........................
CLOSE
......................................................................................................
.......................................................................
............................................................................
First bar:
First bar:
1
Last bar:END
Last bar:END
Number of bars: 2
Number of bars: 2
Loop
•
First bar:
Specifies the first bar of the loop.
•
Last bar:
Specifies the last bar of the loop. In this field, you can also select the
END
so that the last
bar of the sequence is set as the Last bar: even if you change the number of bars in a
sequence in the Main Screen
Bars:
field.
•
Number of bars:
This sets the range of the loop by the number of bars. The number of bars that loop will be
from the bar set in
First bar:
to the number of bars set here.
CAUTION:
First bar:
and the
Number of bars:
as well as the
Last
bar:
and the
Number of bars:
affect each other. If you change the
First bar:
or
Last bar:
, the value of
Number of bars:
will
change accordingly.
Also, by changing the
Number of bars:
, the value of
Last bar:
will change accordingly.