Editing the velocity – Akai MPC 2000xl User Manual
Page 66
Page 55
Chapter 3: Recording Sequences
Editing the Velocity
This adjusts the velocity of the data that is recorded on the selected track when the sequence is
played.
.......................................................
..................................................................................................
Sq:
01-(Sequence01)
TrMUTE
SOLO
Tr +
Now:001.01.00
STEP
EDIT
Tr -
™:120.0(MAS)
Timing:1/16
Tsig: 4/ 4
Tsig: 4/ 4
Count:OFF
Loop: ON
Loop: ON
Bars: 2
Bars: 2
Tr:01-Track-01
ON:YES
Pgm:OFF
S:MIDI :10A-Device10
S:MIDI :10A-Device10
Velo%:
100
Select the
Velo%:
field with the CURSOR keys and set the incremental or decremental ratio of
the velocity with the DATA wheel.
CAUTION: This setting will not directly edit the recorded data. The velocity will increase or
decrease according to the ratio set here only during playback. Also, data with a
maximum velocity (127) will not be affected by values set over 100%.
To edit the velocity of prerecorded data, use the Edit Velocity window.
To display the Edit Velocity window, select the
Velo%:
field and press OPEN WINDOW.
........................
......................................................................................................
....................................................................................................................................
CLOSE
DO IT
Edit Velocity
Edit Velocity
Edit type:
Edit type:
ADD VALUE
ADD VALUE
Value: 1
Value: 1
Time:001.01.00-001.01.00
Notes: 0 (C. )-127(G.8)
Notes: 0 (C. )-127(G.8)
....................................................................................
To directly change the velocity of recorded data, set the following fields and press
DO IT
[F5].
•
Edit type:
Select the method of changing the velocity.
ADD VALUE
Adds the set
Value:
to the current velocity.
SUB VALUE
Subtracts the set
Value:
from the current velocity.
MULT VAL%
Increases or decreases the set
Value:
ratio (percentage) against the
current velocity.
SET TO VAL
Sets all of the velocity values uniformly to the set
Value:
.
•
Value:
Sets the value of the edit method selected in
Edit type:
.
•
Time:
Specifies the data range to be edited when the velocity of the recorded data is edited. Any
data not specified within this range will not be edited.
•
Notes:
Specifies the note range to be edited on the MIDI track when the velocity of recorded data
is edited. Any note not specified within this range will not be edited. On the Drum track,
notes can be entered by pressing the drum pads.