Setting the program change transfer, Locating with the data wheel, Units used to locate a point – Akai MPC 2000xl User Manual
Page 67
Page 56
Chapter 3: Recording Sequences
Setting the Program Change Transfer
You can send program changes on each track in addition to sending program change events
within a track when a sequence is selected.
.......................................................
..................................................................................................
Sq:
01-(Sequence01)
TrMUTE
SOLO
Tr +
Now:001.01.00
STEP
EDIT
Tr -
™:120.0(MAS)
Timing:1/16
Tsig: 4/ 4
Tsig: 4/ 4
Count:OFF
Loop: ON
Loop: ON
Bars: 2
Bars: 2
Tr:01-Track-01
ON:YES
Pgm:
OFF
S:MIDI :10A-Device10
S:MIDI :10A-Device10
Velo%:100
Select the
Pgm:
field with the CURSOR key and set the program number you want to set with the
data wheel. The program change will not be sent if set to OFF.
To display the following window, select the
Pgm:
field and press OPEN WINDOW.
........................
......................................................................................................
....................................................................................................................................
CLOSE
Program change
Program change
Transmit program changes
Transmit program changes
in this track:
in this track:
YES
Set the field to enable (YES) or disable (NO) the transfer of program change recorded on the
selected track. When this is set OFF, the program change will not be sent even if there is a
program change on the track.
Locating with the DATA Wheel
You can locate a point in the sequence with the DATA wheel.
.......................................................
..................................................................................................
Sq:
01-(Sequence01)
TrMUTE
SOLO
Tr +
STEP
EDIT
Tr -
™:120.0(MAS)
Timing:1/16
Tsig: 4/ 4
Tsig: 4/ 4
Count:OFF
Loop: ON
Loop: ON
Bars: 2
Bars: 2
Tr:01-Track-01
ON:YES
Pgm:OFF
S:MIDI :10A-Device10
S:MIDI :10A-Device10
Velo%:100
Now:
001
.01.00
To locate, select the
Now:
field with the CURSOR keys and increase or decrease the number
with the DATA wheel.
Units Used to Locate a Point
You can select bar/beat/clock or hours/minutes/seconds to be displayed in the
Now:
field.
Select the
Now:
field and press OPEN WINDOW.
........................
......................................................................................................
....................................................................................................................................
CLOSE
Time Display
Time Display
Display style:
BAR,BEAT,CLOCK
start time:00h00m00s00f00
Frame rate:25