Connecting a pump start relay – Hunter PRO-C (PCC) User Manual
Page 14
Advertising
14
Connecting a Pump Start Relay
(optional)
1. Route a wire pair from the pump relay into the
controller housing.
2. Connect the pump common wire to the terminal
slot “
COM” (Common) and the remaining wire
from the pump relay to the
P/MV terminal slot.
Relay holding current draw must not exceed 0.28 amps
(24 VAC).
Do not connect the controller directly to the pump—
damage to controller will result.
PSR
P/MV
COM
15 ft (4.5 m) minimum
To pump
Connecting a Pump Start Relay
Advertising