Hunter PRO-C (PCC) - Manual (Page 25)

25
Options for Running Your Irrigation System
Run
After programming is complete, turn the dial to the RUN
position to enable automatic execution of all selected
programs and start times.
System Off
Valves currently watering will be shut off after the dial
is turned to the
SYSTEM OFF position for two seconds.
All active programs are discontinued and watering
is stopped. To return controller to normal automatic
operation, simply return dial to the
RUN position.
Manually Run a Single Station
1. Turn the dial to the MANUAL position.
2. Station run time will flash in the display. Use the i
button to move to the desired station. You may then
use the j and k buttons to select the amount of
time for a station to water.
3. Turn the dial to the RUN position to run
the station (only the designated station
will water, then controller will return to
automatic mode with no change in the
previously set program).
NOTE
The Manual single station function ignores any attached sensor
and will allow watering to occur.
Seasonal Adjustment
Seasonal Adjust is used to make
global run time changes without re-
programming the entire controller.
This feature is perfect for making
small changes that are necessary as
the weather changes. For instance, hotter times of the
year may require a bit more water. Seasonal adjust can
be increased so that the stations will run longer than
the programmed time. Conversely, as Fall approaches,
the seasonal adjust can be reduced to allow for short
watering durations.
1. Turn the dial to the SEASONAL ADJUST position.
2. Press the j or k buttons to set the percentage
desired from 5% to 300%.
To view the new adjusted run time, turn the dial
to set run time’s position. The displayed run times will
be updated accordingly as the seasonal adjustment
is made.
NOTE
The controller should always be initially programmed
in the 100% position.
Options for Running Your Irrigation System