Pentax me super - Manual (Page 5)

23903 Page 4 of 32
4. Bulb off adjustment
Install *the temporary top cover and set the shutter dial Bulb.
Within the range A , 2nd curtain
should be released. Adjust by
eccentric screw.
Confirmation
1) Change the shutter dial 125X. And release the shutter. The shutter
speed should be1/125 sec, not 1/500 or l/l000sec.
2) At the charged condition, release only the shutter block, not push
the shutter button. The shutter speed should be 1/125 sec, not 1/500
or l/l000sec.
*The temporary top cover
5. Dumper lever plate assy. (0-B90)
Adjust the actuating torque by turning Nut (B96).
About 1.5 teeth out from the surface of nut (B96).
The level of actuating torque is depends on the
greatness of mirror bounce.
Confirmation
1) When drop the mirror seat from up-position,
an afterimage of dumper lever plate down and up
can be seen after the mirror seat hitted with
the dumper lever plate.
2) When pushed down the dumper lever plate, and returned slowly, the
dumper lever plate should be returned to the original position
completely by its own tention. If not, check *Friction washer (B94).
*Friction washer (B94)
Material: Calfskin
a. It is prohibited to apply any grease in order to the
material of friction washer (B94) is calfskin.
b. When install, fluffy surface should be faced up.