CBM America CBM-262 User Manual
Page 101
7
Chapter 7
Print Control Codes
92
(58) Cutting of paper (GS V m, GS V m n)
Code:
ᕃ [1D] h + [56] h + m
ᕄ [1D] h + [56] h + m + n
*
ᕃ (0
m
1)
(30
m
31) Data are expressed in Hex code.
ᕄ
(41
m
42)
(0
n
FF) Data are expressed in Hex code.
This command executes the specified paper cut.
m
Function
0,30
Full Cut
1,31
Partial Cut (1 point left)
41
(Cutting position + [n x basic calculation pitch] )
paper feed and full cut.
42
(Cutting position + [n x basic calculation pitch] )
paper feed and partial cut (1 point left).
•
In the Standard mode, this command is valid only if it is input at the head of the
line.
In the case of
ᕃ:
•
When m = 1 or m = 31, a partial cut (1 point left) is executed.
In the case of
ᕄ:
•
When n = 0, after executing paper feed to the cutting position, the paper is cut.
•
When n ( 0, after executing paper feed [n x basic calculation pitch] inch from
the cutting position, the paper is cut.
•
The basic calculation pitch is set by GS P.
•
The paper feed amount is calculated by the vertical basic calculation pitch (y).
Also, if there is a fraction, interpolation is carried out at the mechanism's mini-
mum pitch. Remainders are cut off.