CBM America CBM-262 - Manual (Page 62)

7
53
ᕅ
Error Factor Status (when n = 3 is specified)
Bit Function
Value
0 1
0 Not used Fixed at 0
1 Not used Fixed at 1
2 Fixed at 1 — —
3 Auto cutter error generated No error
Error
occurred
4 Not used Fixed at 1
5 Unrecoverable error No error
Error
occurred
6 Auto recovery error generated No error
Error
occurred
7 Not used Fixed at 0
Bit 3: If this error is generated due to a paper jam, etc., you can recover by DLE ENQ
n (1 n 2) after the error cause is eliminated. If the error was generated due to a
fault in the circuit (broken connection, etc.), then you cannot recover.
Bit 6: If an abnormally high temperature is detected in the print head and during the
time that printing is stopped until the head temperature drops, bit 6 = 1.
ᕆ
Continuous Paper Sensor Status (when n = 4 is specified)
Bit Function
Value
0 1
0 Not used Fixed at 0
1 Not used Fixed at 1
2 Journal near end detection
Paper No paper
present
3 Receipt near end detection
Paper No paper
present
4 Not used Fixed at 1
5 Journal end detection
Paper No paper
present
6 Receipt end detection
Paper No paper
present
7 Not used Fixed at 0
Input Data Format