Boss Audio Systems Boss Digital Panning Delay RPD-10 - Manual (Page 10)

IMPORTANT NOTES AC Adaptor, Power Supply
• For about 10 seconds after the unit is turned on, it
does not function because of the muting circuit.
• When you are using only one AC adaptor {or RPW-7)
for supplying power to more than one unit, please
be sure that the total current draw does not exceed
200mA {or 700mA).
• When the unit is not to be used, disconnect the AC
adaptor from the socket.
• Avoid using the unit in excessive heat or humudity
or where it may be affected by dust or vibration.
• Never remove the cabinet from the unit.
• When you use the unit on its own without using
the optional Rack Mount Adaptor RAD-10, please
attach the rubber feet as shown below.
BOSS PSA-120, 220 or 240 (optional)
BOSS RPW-7 (optional)
Be sure to use the above AC adaptor or power supply.
Using any other adaptor or power supply will cause
trouble.
■ Rack Mounting
The RPD-10 is one of the BOSS Micro Studio Series,
and any two of the series can be mounted in a standard
19" rack (EIA-1U) by using the optional Rack Mount
Adaptor RAD-10.
Remove the rubber feet from the bottom of the units,
fix the units on the Rack Mount Adaptor with the sup­
plied screws, then place the whole set on the rack.
1 0