Input level/input impedance – Boss Audio Systems Boss Digital Panning Delay RPD-10 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
[7] SPECIFICATIONS
Input Level/Input Impedance:
-20dBm/1Ma -10dBm/47kii
Output Level/Output Impedance:
-20dBm/2kn, -10dBm/2kii
Output Load Impedance: Over 10kil
Sampling System:
12 bit quantizing and analog logalithmic
compression system {8 bit when the Delay
Time Range is set to 2s)
Frequency Response:
Direct: 10Hzto60kHz (;|l''
3
dB}
Delay: 20Hz to 15kHz (llgdB)
Residual Noise:
Below — lOOdBm (IHF-A) when the Input
Level Selector Switch is set to -20dBm
Controls:
Delay Time Range (9 steps)
Delay Time Fine
Feedback Level
Delay Tone
Delay Level
Switches:
Power (ON/OFF)
Effect (ON/OFF)
Input Level Selector (-20dBm/“10dBm)
Direct Cancel (Cancel/Mix)
Inidcators:
Power
Effect
Jacks: Inputs (Standard, Pin)
Outputs A (Standard, Pin)
Outputs B (Standard, Pin)
Effect Remote (ON/OFF)
Hold (ON/OFF)
Power:
9VDC (BOSS PSA-120, 220 or 240, RPW-7)
Current Draw:
100mA
Dimensions:
218(W)
X
169(D)
X
44(H)mm/
8ys" X 6%" X 13/4"
Weight:
900g/2 lb
Accessories:
DC Cord (0.5m)
Rubber Feet x 4
OPTIONS
AC Adaptor
PSA-120, 220 or 240
Power Supply
RPW-7
Rack Mount Adaptor RAD-10
Footswitch
FS-5L, FS-5U, FS-1 (Roland)
* Specifications are subject to change without notice.
1
1