Boss Audio Systems Boss Digital Panning Delay RPD-10 - Manual (Page 7)

\E OPERATION
(X) Set the controls on the panel as shown below.
Using the unit as a delay machine
DELAY TIME
/ \
X0.5 xl.o
RANGE FINE
DELAY
i,Q? IQ;
Using the unit as a chorus machine
V' ' '/
/ \
^ y
TONE
Set the Effect Switch to the OFF position.
Set the Direct Cancel Switch on the rear panel to
the MIX position except when a mixer {effect loop)
is used.
( 2 ) Push the Power Switch and make sure the Power
Indicator lights up.
(3) Set the Input Level Selector Switch to either posi­
tion depending on the output level of the device.
® Turn the Effect Switch on {the Effect Indicator
lights up), and delay (or chorus) effect is obtained.
(5) Using the controls on the panel, make a desired
sound. (See page4.)
C> By connecting an optional footswitch (FS-1, FS-5L
etc) to the Effect Remote Jack, the effect can be
turned on or off by pressing the pedal.
* Be sure that the Effect Switch on the panel is
turned on.
* The RPD-10 can be turned from effect to normal
mode without cutting the delay sound currently
played.
I> By connecting an optional footswitch (FS-5U etc.)
to the Hold Jack, the Hold effect can be obtained
as long as the pedal is depressed. The length of
each repeat is the delay time currently set.
* The Hold effect cannot be obtained when the unit is
in normal mode (=effect is off).