Boss Audio Systems Boss Digital Panning Delay RPD-10 - Manual (Page 2)

FEATURES
The BOSS RPD-10 is a completely new type machine
that can create a panning delay effect which was only
possible by using two delay machines.
• This unit can create as long as two second delay
time. ^ The best possible panning effect can be
obtained.
• This unit features Chorus mode. It can be used
as a stereo chorus effect.
• The Direct Cancel Switch is provided. The unit
can send only effect sounds to a mixer.
• This unit features the Input Level Selector Switich
and both a standard phone jack and a pin jack for
input. Not only a musical instrument but also
audio equipment can be used with this unit.
• Using the optional adaptor RAD-10, this unit can be
mounted on a standard 19" rack (EIA).
CONTENTS
[H Panel Description.................................................. 3
Connection ...........................................................6
O Operation.................................................................7
[4] Setting Samples .................................................. 8
[D Setting Memo ...................................................... 9
[S Important Notes .................................................. 10
S Specifications........................................................ 11
RADIO AND TELEVISION INTERFERENCE
'Warning - Thii equipment he« b«en vended to comply with the limitt for a 6 computir^g device,
pursuant (p SuOpert J, of Part 15. of PCC rules. Operation with rkon^ert^ried or non-verrfieq equip­
ment IS iiketY to result m *nterference to radio ar>d TV reception/
The equipment des<rit>e<f in thts manual generates and uses redio-frequer^ energy, if *t is noi
installed and used property, tha\ is, in strict eccordarKe with our instructions, n may cause interfer­
ence With radio end television reception.
This equipment has been tested artd found to com ply with the limits for a Cfass 6 computing
device in accordance with the specifications in Subpari j, of Part 1^. of FCC fiuies. These rules are
designed io provide reasonable protection against such a »nterfarence in a rasidemial installation.
However, there >s no guarentee that the interference win not occur in a particular installation, if this
equipment does cause interference to radio or tatavision reception, which can be determined by turning
the equipment on and off, the user rs encouraged to try to correct the »ntarferertce by the
following meesure:
e Disconnect other devices and their mput'^output cables one at a time, if the interference stops, it
*s caused by anhar the other device or its irO cable.
These davices usualty require Aoiand designated shielded HO cables. For floiand devices, you can
obtain the proper shielded cable from your dealer. For non Roland cfevices, contact the manufeciurar
or dealer for aisiiiartce.
If your equipment does cause interfarence to radio or taiavision reception, you can try to correct
the miorference bv usmg one or more of the foiTowing maasures:
• Turn the TV or radio antenna until the mterferer>ces stops.
• hiqya the equipment to one side or the other of the TV or radio,
• Move the equipment farther away from the TV or radio.
Plug the equipment into an outlet that *s on a different circuit than the TV or radio. (Thai is, make
certain the equipment and the radio i
breakers or fuses.)
Consider installing a rooftop leiev
TV,
r tsfayision set are on circuits controlled by different <
antenna with coaxial саЫе faad-m batweti and
If necessary, you should consuTt your deater or an experieisced radiO'^teiav^siorv technician for
additional suogtstions. Vou may fmd helpful ff^ following booklet prepared by tha Federal Com-
munications vommision:
"Hovr to identify and Resolve ftadio*TV interference Probtems'
This booklet is available from the t>.$. Covernmant Printing Office, Washington, D.C, 2040?,
Stock hro. 004 000-0034S.4.
Bescheinigung des Herstellers/Importeurs
Hiermit wird bescheinigt, daß der/die/das
• BOSS DIGITAL PANNING DELAY RPD-10
tGe.'Si typ Bcrrhcrwxjnq)
in Übereinstimmung mit den Bestimmungen der
Amtsbl, Vfg 1046/ 1984
<AmTsO£auviMlugung)
funk-enstort ist.
Der Deutschen Bundespost wurde das Inverkehrbringen dieses Gerätes
angezeigt und die Berechtigung zur Überprüfung der Serie auf Einhaltung der
Bestimmungen eingeräumt,
Roland Corporation Osaka/Japan
NA’vy o«. iniponeu'S