Boss Audio Systems Boss Digital Panning Delay RPD-10 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
* Changing this switch does not affect the volume
of the sound.
0 Ouput Jacks A
Connect this jack to a device such as guitar amplifier,
stereo amplifier or tape deck. (Both the standard and
pin jacks can be simultaneously used.)
* Use this jack for monaural use.
® Output Jacks B
By using this jack together with the Output Jack A
in stereo, panning effect can be obtained. (Both the
standard and pin jacks can be simultaneously used.)
Effect Remote Jack
By connecting a footswitch FS-5L (optional) to this
jack, Normal/Effect mode can be selected using the
pedal.
* Make sure that the Effect Switch on the panel is
turned on.
When using two sets of the BOSS Micro Studio Series,
it may be a good idea to connect the Effect Remote
Jack of one unit to another one, so that you can turn
on or off the effects of both units simultaneously by
operating one unit.
Hold Jack
This jack is to connect the FS-5U (optional footswitch).
As long as the footswitch is depressed, the input sound
will be repeated.
* The Hold effect cannot be obtained when the unit is
in the normal mode (=effect is off)
Direct Cancel Switch
When this switch is turned on, direct sound is cut,
only the delay (or chorus) sound being sent out. This is
useful for effect-loop use of a mixer.
AC Adaptor Jacks
The "IN" jack is to connect the AC adaptor (BOSS
PSA-120, 220 or 240) or the Power Supply (BOSS
RPW-7). Connect the plug of the AC adaptor or the
Power Supply to "IN". To supply power to other
BOSS Micro Studio Series, connect the supplied DC
cord to "OUT".
* When using the PSA-Adaptor, be sure the total
current draw does not exceed 200mA, and when
using the RPW-7, 700mA. (The current draw of
each unit is shown on its rear panel.)