NewAir AH-320E User Manual

Page 6

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

reduce the height, press in the height adjustment button and simultaneously push the

sliding column down. Release the button to set.

Heater Head Adjustment: Grasp the reflection hood and gently tilt forward or backwards.

The unit will click into the different positions. (Notice: When adjusting the heater head, the

heater must be turned off to ensure safety.)

NOTE: A tip-over safety protection switch is installed at the bottom of the heater. When the
heater is not placed horizontally, laid down or lifted up, it stops operating to ensure safety.
After placing the heater upright it will resume operation.

NOTE: For safety, if the heater’s internal temperature rises above a certain point, the heater

is designed to automatically shut off To restart the heater in this situation:

1. Push the power button to ON/OFF.

2. Unplug the power cord from the outlet and allow the heater to cool for at least 10 minutes.

3. Plug the power cord back into the outlet. Use the control panel to select the desired

settings.

WARNING: It is normal for the power cord to feel warm to the touch; however, a loose fit

between the outlet and the plug may cause overheating of the plug. If this occurs, try inserting
the plug into a different outlet. Contact a qualified electrician to inspect the original outlet for

damage.

MAINTENANCE

1. Unplug the unit and let it cool completely.

2. To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You

may use a mild detergent if necessary. After cleaning, dry the unit with a soft cloth.

CAUTION: DO NOT let liquid enter the heater.

3. DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to

clean the heater. This may cause damage or deterioration to the surface of the heater.

4. DO NOT immerse the heater in water.

5. Wait until the unit is completely dry before use.

STORAGE

Store the heater in a cool, dry location when not in use. To prevent dust and dirt build-up, use the

original packaging to repack the unit.

TROUBLESHOOTING

If the heater will not operate, please check the following before seeking repair of service:

5

Advertising