Bolens 190756 - Manual (Page 3)

N
4. Never tamper with safety devices. Check their proper operation
regularly. Use all guards as instructed in this manual.
5. To reduce fire hazard, keep machine free of grass, leaves or
other debris build-up. Clean up oil or fuel spillage. Allow
machine to cool before storing.
6. Stop and inspect the equipment for damage if you strike an
object (e.g. rock). Repair, if necessary, before re-starting and
operating the machine.
7. Never make adjustments or repairs with the engine running.
8. Check brake operation frequently. Adjust and service as
required.
9. Muffler, engine, and belt guards become hot during operation
and can cause a burn. Allow to cool down before touching.
10. Do not change the engine governor settings or overspeed the
engine.
A
Your unit was built to be operated according to the rules for safe operation in this manual. As with any type
DANGER: of power equipment, carelessness or error on the part of the operator can result in serious injury. If you vio­
late any of these rules, you may cause serious injury to yourself or others.
ASSEMBLY
N
■N,
Contents of Hardware Pack (See figure 1):
A
(1) Extension Spring
B (2) Flat Washers 1/2“ I.D. x 1-1/2" O.D.
C
(1)
Flat Washer 5/8" I.D. x 1-1/4" O.D.
D (2) Flat Washers 1/2" I.D. x 1" O.D.
E (6) Hex Bolts 3/8-24 x 7/8" Long
F (6) Lock Washers 3/8" I.D.
G (6) Hex Nuts 3/8-24 Thread
I (1) Spiral Pin
J (5) Hairpin Clips 1/2" Diameter
K (4) Extension Springs (Not Shown)
M (1) Hex Bolt 1/4-20 x 1.25“ Long*
N (2) Cupped Washers 1/4" I.D.*
0 (2) Hex Nuts 1/4-20 Thread*
P (1) Ferrule
Q (1) Spacer 1/2" I.D. x 1" O.D. x 1/2" Long
R (1) Shoulder Bolt
S (1) Lock Washer 1/2" I.D.
T (1) Hex Jam Nut 1/2-20 Thd.
u
(1) Flat Washer 1/2" I.D. x 1-1/4" O.D.
V (2) Split Spacers .505" I.D. x .57" O.D.
w (1) Hairpin Clip 3/8" Dia.
X (2) Flat Washers 3/8" I.D. x 5/8" O.D.
Y (2) Hex Bolts 5/16-18 x 3-1/4" Long
*Not used on all models
FIGURE 1.