Bolens 190756 - Manual (Page 5)

s
Hex Bolts (E)
Lock Washers (F)
Hex Nuts (G)
N
FIGURE 5
6. Align the holes in the support pivot bracket with
the holes in the tractor frame. Secure the support
pivot bracket to the tractor frame with hex bolts
(E), lock washers (F) and hex nuts (G) as shown
— in figure 5.
7. Assemble the other support pivot bracket to the
right hand side of tractor in the same manner,
securing shaft on tractor with hairpin clip removed
in step 3.
8. Tighten securely all four nuts and bolts which
were used in assembly of pivot support brackets.
9. Secure end of idler bracket support arm assembly
on the right side of tractor with one flat washer
(D) and hairpin clip (J).
10. Place carriage bracket assembly (AA) in position
beneath the running board support rod on the
tractor so belt will attach to engine pulley. Secure
each side of carriage bracket to frame with hex
bolts (E), lock washers (F) and hex nuts (G).
------Tighten securely. See figure 6.
Carriage Bracket
Assembly (AA)
FIGURE 6.
Round
Belt
Guard
i;
Hairpin Clip
Belt
Guard
Release
Wire
Beit
Guard
fdler Pulley
B Hex Bolts
(Belt Keepers)
Round
Belt
Guard Hairpin
Clip
Idler Pulley
11. If so equipped, remove the round belt guard from
the idler on tractor by removing the hairpin clip.
------See figure 7A or 7B.
12. Remove the engine pulley belt guard by either
unscrewing the belt guard release and swinging
the engine pulley belt guard out of the way (see
figure 7A), or removing the two long hex bolts
which act as belt keepers (see figure 7B).
13. Place the belt which is preassembled to the car­
riage bracket assembly around the idler pulley
and engine pulley on the tractor.
14. Reassemble the round belt guard and hairpin clip.
Reassemble the engine pulley belt guard(s).
FIGURE 7.