Bolens 190756 - Manual (Page 6)

15. Place the tiller in position behind the tractor.
16. There is a weld pin on the front of the tiller on the
right hand side. Push the tiller forward, then to the
left so the weld pin goes through the bottom hole
in the right hand pivot support bracket. See figure
-------- 8 .
17. Secure the weld pin using flat washer (D) and
hairpin clip (J).
FIGURE 8.
Support
Pivot Bracket
FIGURE 9.
18. Secure the left hand side of tiller to the support
pivot bracket using shoulder bolt, lock washer
and hex jam nut provided. Head of the shoulder
bolt must be to the inside of the tiller. See figure
^---------9.
19. Thread the adjustment ferrule (P) onto the end of
the lift rod assembly a few turns. Slide the ferrule
and the lift rod assembly through the slot in the
right hand tractor fender.
NOTE: On models prior to 1984, it is necessary to
extend the slot in the fender approximately 1-1/2" fur­
ther down toward the running board. The siot should
measure approximately 4-3/8“.
20. Attach the lift rod assembly to the rod which is
part of the pivot bracket assembly as follows. See
------ figure 10.
A. Place flat washer (U) over the rod on the pivot
bracket assembly.
B. Slide the slot on the bracket (part of the lift
rod assembly) over the rod (bracket must
point upward).
C. Place one flat washer (B) over rod, then two
spacers (V). Secure with hairpin clip (W).
D. Place one flat washer (X) over one hex bolt
(Y). Hook one compression spring between
the two spacers just assembled in step C.
Insert the hex bolt (Y) through the bracket on
the lift rod assembly and start it into the com­
pression spring.
E. Start the other spring in the same manner,
hooking it over the rod on the pivot bracket
assembly (to the inside of the bracket). Now
tighten both bolts (Y) securely.