Bolens 190756 - Manual (Page 4)

FIGURE 2.
Use This Hole
For Mounting
Idler Bracket
Support Arm
Support Pivot
Bracket (CC)
Hammer
Ail Other Tractors
Supp< >rt Pivot
Bracl:et (CC)
'Loose Parts in Carton (See figure 2):
AA (1) Carriage Bracket Assembly
BB (1) Idler Bracket Support Arm Assembly
CC (2) Support Pivot Brackets
DD (2) Compression Springs
EE (1) Idler Bracket Assembly
FF (1) Lift Rod Assembly
Support Arm (BB)
Idler Bracket
Assembly (EE)
NOTE: Right and ieft hand side of the unit is deter­
mined from the driver’s seat, facing forward.
1. Remove the cutting deck from your tractor if one
is attached.
2. Preassemble the idler bracket support arm (BB)
to one support pivot bracket (CC) and idler brack­
et assembly (EE) as follows.
A. Place the idler bracket support arm down
through the hole in support pivot bracket
---------- shown in figure 3. Then slide the idler bracket
assembly over the idler bracket support arm.
B. Secure the idler bracket assembly to the idler
bracket support arm using spiral pin (I), using
the hole in the idler bracket support arm as
follows. See figure 3.
14 Speed Tractors: Secure by placing spiral pin in
the hole further away from the support pivot bracket.
All Other Tractors: Secure by placing spiral pin in
the hole nearest the support pivot bracket.
FIGURE 3.
Hairpin
Clip
3. Remove the two hairpin clips from the shaft on
■ the rear of your tractor. See figure 4. These will
be reassembled in steps 4 and 7.
4. Place the support pivot bracket (with idler bracket
and support arm attached) in position on the rear
left hand side of tractor. See figure 5. Place large
hole in pivot bracket over shaft on tractor. Secure
with one hairpin clip removed in step 3.
5. Remove the transmission cover for easier access
when installing the support pivot brackets to the
tractor frame.
FIGURE 4.