Bolens 190756 - Manual (Page 7)

N
Flat
X "^Washer (C)
^Hairpin Clip (J)
21. Move the lift lever on the tractor to the second
notch on the index bracket as shown in figure 11.
22. Place a board under the tines. Thread the ferrule
onto or off of the lift rod until it lines up with the
bottom hole in the lift handle. Secure ferrule to lift
handle using flat washer (C) and hairpin clip (J).
------ See figure 11.
NOTE: Refer to operation section for additionai
adjustment information.
FIGURE 11.
I \ \
Extension Spring
1/
Bracket
Hole in
Tractor
Hydrostatic Tractors,
1989 & After
B
Hex Bolt (M)
Cupped Washers (N)
Hex Nuts (O)
Extension Spring (A)
Bracket
7 & 14 Speed
Hex Bolt (M)
Cupped Washers (N)
Hex Nuts (O)
Extension Spring (A)
, Bracket
Long End A \y^
of Spring ^ '
4 & 5 Speed
23. Hydrostatic tractors, 1989 production and
after: Attach spring (A) by hooking long end of
spring into hole on end of bracket attached to
pivot bracket support. Hook short end of spring
into hole in tractor frame as shown in figure 12A.
24. All other units: Attach spring (A) as follows.
A. Thread one hex nut (O) all the way onto hex
bolt (M). Place one cupped washer (N) on hex
bolt, with the cupped side of washer against
the hex nut.
B.--Place hex bolt into hole in tractor frame as
----------- shown in figure 12B or 12C according to the
type of tractor (four, five or 14 speed). Secure
using cupped washer (N) and hex nut (O),
with the crowned side of washer against the
inside of the frame.
C. Hook the long end of spring over hex bolt.
Hook short end of spring into hole on end of
bracket attached to pivot bracket support.
FIGURE 12.