T. preoperational instructions coinmodels, J. preoperational instructions – American Dryer Corp. AD-385 User Manual
Page 33
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
T. PREOPERATIONAL INSTRUCTIONS
COINMODELS
1. Timed Mode (Microprocessor fComputerl Models^
a. When turning on power or when no cycle is in progress, the LED display will read "FILL" and/or "Amount
to Start".
b. Insert coin(s). Once correct "Amount to Start" has been inserted, the LED display will read "PUSH".
c. Select temperature by pushing "HI TEMP", "LO TEMP", or "PERM PRESS". The dryer will start, and the
LED display will read the temperature cycle selected and the drying time.
d. The dryer will continue through the drying and cooling cycles, showing time counting downward.
NOTE; If the door is opened during a cycle, both the heat and motor will stop. However, the
microprocessor controller (computer) will continue to count down in time. Continuation of the
cycle will resume only after the door has been closed and any one of the three (3) temperature
selection buttons is again depressed.
e. Upon completion of drying and cooling cycles, the tone (buzzer) will sound for five (5) seconds, and the
LED display will read "donE", at which time the dryer will shut off.
NOTE: 1. If the anti-wrinkle program is active, the LED display will continue to read "donE", and the
microprocessor controller (computer) will proceed through the anti-wrinkle program until the
maximum "Active Guard Time" has expired or until the door is opened, whichever comes first.
The LED display will read "FILL" and/or "Amount to Start".
2. If the anti-wrinkle program is not active or in use, the LED display will read "FILL" and/or
"Amount to Start".
2. Automatic Mode (Microprocessor fComputer] Models)
a. When turning on power or when no cycle is in progress, the start LED display will read "FILL" and/or
"Amount to Start".
b. Insert coin(s). Once the correct "Amount to Start" has been inserted the LED display will read "PUSH".
c. Select temperature by pushing "HI TEMP", "LO TEMP", or "PERM PRESS". The dryer will start, the
LED display will read the temperature cycle selected, and the drying time portion of the LED display will
read "00" and count upward as time elapses.
NOTE: If the door is opened during a cycle, both the heat and motor will stop. However, the
microprocessor controller (computer) will continue to count downward in time. Continuation
of the cycle will resume only after the door has been closed and any one of the three (3)
temperature selection buttons is again depressed.
29