Lef-5 w/8 ohm horn (ah-108 in usa), Mounting, Lef-5,10,10s – Aiphone LEF-3 User Manual
Page 8: Le room subs, Wall-mounting, Wall surface-mounting or desk use
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
LEF-5 w/8 ohm horn (AH-108 in USA)
LEF-5
★ Shorting link on E - - attached on
LEF-5 in single-master configuration.
EB: PS-12CorPS-12A
MOUNTING
SINGLE-GANG
BOX
• LEF-5,10,10S
• LE room subs
Unplug
SINGLE-GANG
BOX
LEF-5/10/10S
intercom
Chassis
2 screws supplied
★ 2
SINGLE-GANG BOX
★ Prongs(4)
"Oil
2 screws supplied
★ 1 , 2 : When running cable on surface, pass cable through top or bottom section,
and fasten with a clamp (attached).
★ Slide LE unit until it locks with the prongs.
■ Wall-mounting
1. Remove the directory card by pressing down on one
side and lifting off from the middle.
2.
Loosen the two screws. (Do not remove screws from
front case.)
3.
Disconnect LEF intercom from the chassis by
unplugging connectors.
4.
Mount the back chassis to a single-gang box.
5. Terminate wires on screw terminals inside the chassis.
6.
Reconnect intercom with connectors and mount to
chassis.
■ Wall surface-mounting or desk use
1. Plug in CN-1 & CN-2 connectors of LEW-5, LEW-10, or
LEW-1 OS to multi-pin sockets inside LEF master
(Connectors from chassis disconnected). Use clamps
on LEF back case to secure cable.
2.
Install the terminal box in a convenient place with the
field wiring connected to it. The cord from the box to the
LEF unit is approx. 77” long.
• Surface wall-mounting;
- 8 -