AEG 860 D User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Additional
installation
work for return
air operation
38
Installation steps same as for exhaust air operation under
points 1 —4
Further installation steps:
5. Slide guide piece
(Fig. EO/9)
on to chimney cover plate
(Fig. EO/4).
6.
Fix exchaust air hose on guide piece with 125 mm dia. hose
clip.
7. Fix chimney equalizer as under exhaust air..
8.
Unclip the ventilation grille
(Fig. EO/8)
from the chimney
cover plate and, after pulling off the foil (double adhesive
tape)
(Fig. EO/7),
slide the chimney cover plate from the
front on to the fume extractor hood until it engages the hol
ders on the RFI and LH sides
(Fig. EO/10).
9. Fix chimney cover plate
(Fig. EO/2)
laterally with 4
2.9 x 6.5
mm sheet metal screws on the chimney retaining plate.
10.
Clip the ventilation grille laterally (on the RH and LH sides)
on the guide piece
(Fig. EO/9).
Important! Lamination position obliquely downwards!
Unless this has been done as preparation work, 2 KL 600 car
bon filters (E-No. 610 899 470) (for your own account from our
range of special accessories) must be inserted for return air
operation!