Aiwa LCX-350 - Manual (Page 13)

BASIC RECORDING
4 Press the • button to start recording.
/ /iW
/ I I
(liip) '
I I j I I I I
_f
J . u u
When the selected function is CD, piayback and recording
start simultaneousiy.
When the seiected function is AUX, start piayback on the
connected equipment.
To stop recording, press the ■ button.
To pause recording, press the
II button. (Applicable when the
source is TUNER or AUX.) To resume recording, press again.
To start recording with the remote control
First press the ® button, and then press the !► button within 2
seconds.
i C
QQ^
r
Preparation
• Set the tape to the point where recording will start.
• Only Type I (normal) tapes can be recorded.
Recording cannot be done when the TAPE function is selected.
1 Insert the tape to be recorded on into the deck.
Insert the tape with the side to be recorded on first facing
out from the unit and the exposed side down.
2 Press theTAPE button to select the reverse mode.
To record on one side only, select T.
To record on both sides, select Z5 or CZ).
3 Press one of the function buttons and prepare
the source to be recorded.
To record from a CD, press the CD button and load the disc.
To record from a radio broadcast, press the TUNER button
and tune in to a station.
To record from the connected source, press the AUX button
and prepare to play.
INSERTING BLANK SPACES
Insertion of 4-second blank spaces may help you to locate the
begining of the track on other equipmetit. (Applicable when the
source is TUNER or AUX.)
1 Press the • button during recording or while in recording
pause mode.
flashes for 4 seconds and the tape runs without
recording. After 4 seconds, the deck enters the recording
pause mode.
2 Press the II button to resume recording.
To insert a blank space of less than 4 seconds, press the •
button again while Iil4«i is flashing.
To insert blank spaces of more than 4 seconds, after the
deck enters recording pause mode, press the • button again.
Each time the button is pressed, a 4-second blank space is
added.
To erase a recording
1 Insert the tape to be erased into the deck.
2 Set the tape to the point where the erasure is to be started.
3 Set the reverse mode by pressing the TAPE button.
4 Press the AUX button.
If an optional equipment is connected to the AUX jacks, turn
it off.
5 Press the • button to start the erasure.
ENGLISH
1 2