Aiwa LCX-350 - Manual (Page 6)

BEFORE OPERATION SETTING THE CLOCK
■Function
buttons
To turn the unit on
Press one of the function buttons (TAPE, TUNER, AUX, CD).
Playback of the inserted disc or tape begins, or the previously
tuned station is received (Direct Play Function).
The POWER button is also available.
After use
Press the POWER button to turn off the power. The display
changes to the clock.
Using the headphones
Connect the headphones to the PFIONES jack with a stereo mini
plug (03.5 mm, Ve inch).
No sound is output from the speakers while the headphones are
plugged in.
When the AC cord or the car battery cord is connected for the
first time, the time on the display flashes.
Set the time as follows while the power is off.
1 Press the II button.
The hour flashes.
f
I U 4
H i I
I
I i
I I 1 1 I
■ /
I I I
2 Press the ◄◄ or
hour.
button to designate the
3 Press the II button to set the hour.
The hour stops flashing and the minute starts flashing.
4 Press the ◄◄ or ►► button to designate the
minute.
5 Press the II button to set the minute and
complete setting.
The minute stops flashing on the display and the clock starts
from 00 second.
To correct the current time
Press the POWER button to turn the unitoff. Press the II button,
the clock display flashes and carry out steps 1 to 5 above.
To display the current time
Press the CLOCK button while pressing the SFIIFT button on
the remote control. The time is displayed for 4 seconds.
However, the time cannot be displayed during recording.
To switch to the 24-hour standard
Press the CLOCK button while pressing the SHIFT button on
the remote control and then press the ■ button within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes while the power is off
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 12 hours, all
settings stored in memory after purchase need to be reset.
5
ENGLISH