Manual tuning, Press the ◄◄ or ►► button to select a station, When an fm stereo broadcast contains noise – Aiwa LCX-350 User Manual
Page 8: To change the am tuning interval, To search for a station quickly (auto search), J u . u u
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
I
MANUAL TUNING
BAND/
MODE
TUNER
SHIFT
1 Press the TUNER button repeatedly to select the
desired band.
► FM -►AM-
If the power is turned off, the previously tuned station will be
played (Direct Play Function).
When using the remote control, press the BAND/MODE
TUNER button repeatedly while power is on.
Press the ◄◄ or ►► button to select a station.
Each time the button is pressed the frequency changes.
When a station is received, "TUNE” is displayed for 2 seconds.
During FM stereo reception, "STEREO" is displayed.
ISTEREOl
ilSTEREOi
/ / /. / r
U I 'I I-
When an FM stereo broadcast contains noise
Press the BAND/MODE TUNER button while pressing the SHIFT
button on the remote control.
“MONO" appears on the display.
Noise is reduced, although reception is monaural.
/i/f
I I
I I n n i l
J u . u u
To restore stereo reception, press the buttons again.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
Press the POWER button while pressing the TUNER button
during power on.
To reset the interval, repeat this procedure.
When the AM tuning interval is changed, all preset stations
(see "PRESETTING STATIONS”) are cleared. The preset
stations have to be set again.
To search for a station quickly (Auto Search)
Keep the ◄◄ or ►► button pressed until the tuner starts
searching for a station. After tuning in to a station, the search
stops.
To .stop the Auto Search manually, press the ◄◄or ►► button.
• The Auto Search may not stop at stations with very weak
signals.
7
ENGLISH